The automatic temperature function will only operate on "High" heat. You cannot set the temperature automatically when the unit is in the low heat mode.
1. To set the room at a specific temperature press the (+) or (-) buttons to the desired temperature. The display will now reflect the A with a circle around it and the temperature will be flashing. The Heater is now in Auto Temperature Mode.
2. When you reach the temperature at which you want to set the unit, the set temperature will flash several times and then the display will return to indicate the current room temperature and will gradually change as the room temperature changes. NOTE: the temperature display does not indicate the temperature of the heated air being emitted by the heater.
3. Once the room temperature reaches 2 degrees above the set temperature, the Heater will shut off. Once the room temperature reaches 1 degree below the set temperature, the Heater will turn back on and continue to cycle off and on to maintain the set temperature.
4. This function will cancel if the power button is pressed. The Heater will now be in High heat (III) and run continuously. NOTE: It is normal for the Heater “fan” to run for approximately 15 seconds when the Heater shuts off after reaching the set temperature
Comments
0 comments
Please sign in to leave a comment.