George

Box fans blades are held on friction tight. There is no spinner or screw that is used to hold the blade on. The blade tightens as it runs which holds it on the motor shaft. Below explains how to re...

Some Air king fans use pop rivets to secure the feet to the bottom of the fan, or to the yoke of the fan. These rivets are used as they are resistant to vibration and have low-profile heads for a c...

The thermostat on a fan works by setting the fan to a temperature in which the fan will turn on at. For example,  if the fan is set to 80 degrees, the fan will turn on when the room temperature the...

If a you purchase a YY11200 Filter-pack for model HF11200, it is important to note how the filters will be arriving. See below for details.    By design, the Air Purifier comes with three filters,...

All Lasko residential fans use AC Power. Below is a bit more about AC Power What is AC Power? Alternating current describes the flow of charge that changes direction on and off. As a result, the v...

Lasko fans are in compliance with CARB (California Air Resources Board) and these products are below the current threshold that is set, which is currently 0.070 ppm per the EPA national eight-hour ...

The intent of the beeping sound when adjusting your settings for your heater is to announce that the heater is on, and the features are being adjusted. The design is intentional and for safety reas...

A heater is designed to be powered off and unplugged when not in use, for safety reasons. By design, when the heater is plugged in there is an audible beep which announces that the heater has been ...

A heater by design is to be powered off and unplugged when not in use, for safety reasons. The red indicator light turns on when the product is plugged in. This is to notify you that the heater is ...

The red indicator light turns on when the product is plugged in. This is to notify you that the heater is plugged in and power is going to the unit. This light cannot be turned off for safety reaso...