Cyclone Floor Fan Cleaning (rear-mounted controls - non Wind Machine))

Please be sure to have a Phillips and Flat head screwdriver available to disassemble the product.

1. Be sure the product is unplugged then lay the fan face down on a flat stable surface. The rear grill should be facing you.

2. Locate and remove the 2 screws along the outer edge of the back grill (between the spokes).

3. Turn the fan over so the front of the fan is facing you. Place a Flat head screwdriver into the gap between the front and rear grills (near the rear grill tabs). Gently push down and pull the front grill towards you, exposing the fan blade. Do not remove the side knobs on the product.

4. Wipe the blade with a soft damp cloth. Use a mild detergent if necessary. Be very careful that no water comes into contact with the motor. This will damage the motor and the fan will become inoperable. After cleaning, reassemble the fan. Your fan will now be ready for operation.